GRASS VALLEY JUPITER CM-4400 - VERSION 7.9.0 - 10-2010 - Dedicated CM-4400 Per Switcher; Connection to Multiple Distribution Switchers with Path Finding

66 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 2 — Hardware Installation
DEDICATED CM-4400 PER SWITCHER
By using separate CM-4400s, physical level numbers may be duplicated
from one switcher to another. When expanding a system, the need to
change the DIP switches or jumpers on the routing switcher is eliminated.
See Figure29.
Figure 29. Multiple Switcher Installation with Dedicated CM- 4400
Connection to Multiple Distribution Switchers with Path Finding
Note Data router Path finding is not supported.
The path finding software option allows two or more Jupiter-controlled
routing switchers to operate as a system. That is, one switcher can access
the other’s inputs through a number of tie lines. These tie lines can vary in
number from one switcher to another, and from one level to another.
CC−2010 Matrix cables.
50 ft. (15.2 m) max.
CC−2010
Physical level 1
Video
Physical level 2
Left audio
Physical level 4
Right audio
“NEWSROUT”
CB−3000 Control Buffer.
Required when more
than 50 matrix boards
are installed in switcher.
Physical level 1
Video
Physical level 2
Left audio
Physical level 6
Right audio
“MAINROUT”
Hub
10/100baseT
Jupiter LAN
CM 4400 System Controller
CM 4400 System Controller
Crosspoint Bus port
Crosspoint Bus port