GRASS VALLEY JUPITER CM-4400 - VERSION 7.9.0 - 10-2010 - CM-4400 Connections; Connecting the CM-4400 to the Jupiter LAN

40 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 2 — Hardware Installation
Connecting the CM-4400 to the Jupiter LAN
The Routers, Control Panels, and PC's that comprise the Jupiter Control
System communicate through the CM-4400 on the Jupiter LAN. The IP
address that is defined as the Base IP is assigned to the first controller in the
system when loading the Jupiter Control Software. The other CM-4400s are
assigned their IP addresses by automatically incrementing addresses fol-
lowing the first controller’s address.
CM-4400 Connections
This section describes the connections on the rear panel of the CM-4400.
Figure 6. CM-4400 Connections
Follow these steps to connect the System controller to the routers:
1. Connect the Crosspoint Bus cable to the XPT BUS connector on the rear
of the CM-4400 controller and the other end to either the BOP-4000, one
of the XPT BUS connector on the rear of the router, or the CB 3000.
(Figure6)
2. Connect the redundant CM-4400 if needed.
Note When adding up all XPT Bus cable segments, the approximate maximum
length is 50 feet. There is also a load limit for how many connections that can
be on one bus. See CM-4400 Serial Bus Loading on page 281 for more infor-
mation,
0718766
00_CM-4400-Rearpn
l
Time Code 8 Serial ports LANXPT Bus