JUPITER CM-4400 Control Module Installation and Operating Manual 251
4. Enter the time frame for which you want to delete events that are older.
In the example in Figure 207 on page 250, all events older than three
days will be deleted.
5. Click the OK button to save the settings. Clicking the Cancel button will
close the dialog without saving the changes.
Running the JNS Log Viewer
The JNS Log Viewer can display Jupiter LAN activity as it happens, even if
the JNS Logger has not been started. However, the JNS Logger must be
running in order to capture the events; that is, have them saved to a file
automatically.
To run the Log Viewer, select Start > Programs > Jupiter Network Suite >
Log V
iewer.
Figure 208. The LogViewer (Dynamic Data) Dialog
Dynamic Displays
When the Log Viewer is first started, it will be in the Dynamic Data mode.
That is, all displays will show Jupiter LAN activity as it happens. The
Dynamic Data mode will hold up to 256 lines of information.
Follow these steps to open a Dynamic Display:
1. Select the View menu from the Menu bar of the LogViewer.
2. Select the preferred Dynamic Displays from the drop-down menu
(Figure 209 on page 252).
To Next Page
Loading...