GRASS VALLEY JUPITER CM-4400 - VERSION 7.9.0 - 10-2010 - Page 110

110 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
Figure 73. The Jupiter Configurator
•Use the Open command (File > Open) to select an existing configu-
ration set; the full path and name of the set will appear in the
window’s title bar.
•Use the New command (File > New) to create a new set.
The last set that was used will be opened automatically when Configu-
rator is started again.