172 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
2. Select the appropriate radio button in the Type of Set area of the dialog.
The names of any previously created set will then appear in the sets:
window.
• The Category Set drop-down list will only be seen if the Input and
Output radio button is selected.
The buttons will be grayed out.
3. Enter an eight character name for the Input set in the Name field.
4. Select the “CPESXTND” CP Type option from the drop-down list.
5. Select a CP set from the Category Set drop-down list or use the
“default” option, as appropriate.
6. Click the Apply button. The name of the new output will then appear in
the Output Sets: window. The buttons will become active.
To Next Page
Loading...