224 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
Path finding
Path finding is supported for WAN applications. However, when config-
uring the Path finding tables, the entr
ies in the Physical Output and Phys-
ical Input columns are not the actual phys
ical input and output numbers
(i.e., they are not the physical" numbers shown in the Switcher Input and
Output tables). Instead, the Path finding tables use the Entry numbers from
the CP Input and CP Output set tables assigned to the CM that is control-
ling the target matrix router.
To Next Page
Loading...