292 JUPITER CM-4400 Control Module Installation and Operating Manual
Appendix B — Connecting Legacy and 3rd Party Routers
Figure 226. Cable for Connecting CM- 4400 to Datatek D-2166 Buffer Control Module
Utah Scientific Party Line Connection Using UDI-1B
The CM- 4400 can be connected to a Utah Scientific Party Line through a
UDI-1B Universal Data Interface (see Figure 227). Some UDI-1B units are
equipped with a 9-pin RS-422 port; others ar
e equipped with a 25-pin RS-
232 port. Either type can be used.
The protocol for the UDI-1B port must be set
at: 9600 baud, 7 data bits, even
parity, and 2 stop bits. The UDI-1B must be equipped with software version
81.4 or later. The UDI-1B “AUX” rotary switch needs to be set to “E” for
“PL-160 Mode” and to enable all mode commands. Refer to the UDI-1B
manual for detailed procedures.
Note If the RS-232 port is used, it is advisable to use an RS-422 to RS-232 con-
verter. A Black Box, model GJ-IC455B Interface/converter, is available from
Grass Valley.
1
6
R−
2
7
3
T−
8
4
9
5
T−
R+
to CM 3000
serial port
to Datatek D−2166/DF−2115
“RS−232−C A” or “RS−232−C B” port
jumpered for RS−422 operation. Refer
to the manual supplied with the Datatek
router for more information.
G Ground
R− Receive minus
R+ Receive plus
T+ Transmit plus
T− Transmit minus
DB9P
(male)
= twisted pair
T+
R−
R+
G G
T+
071826105_Cable for Connecting CM 4000 to Datatek D−2166
To Next Page
Loading...