KARRERA — Installation & Service Manual 119
Engineering Setups
Outputs Menu
The Outputs menu is used to change the Karrera system output assign-
ments. The current output assignments can be viewed in this menu. Press
Eng Setup, Outputs to access this menu (Figure 73).
Figure 73. Outputs Menu
The scrolling list of data pads along the left side of the screen shows the cur-
rently assigned output for each listed module output connector. The right
side of the menu shows the items available for assignment to that output
connector. Different choices appear, depending on the
Output Type selected.
To Change Output Assignments:
1. Touch one of the output data pads from the left scrolling list to select it
and display information for that output connector.
2. Select the appropriate Output Type:
• Select Fixed if the output is to be dedicated.
• Select Switched PVW if the output will be used for switched preview.
Switched preview can be assigned to multiple outputs.
• Select Aux if the output will be an Aux bus (see Aux Bus Configuration
on page 120 for more information).
To Next Page
Loading...
