KARRERA — Installation & Service Manual 245
Video Processor Frame Maintenance
General Control Panel Lid Switch Board Remove and Replace
In general, switch boards in the panel lid can be replaced as follows:
1. Power down and unplug panel from its power source.
2. Label any sockets and cables before you unplug them to ensure the
cables are replaced in the correct sockets. This is especially important if
you will be removing more than one board.
3. Disconnect the data and power cables from the board.
4. Remove the screws (from four to seven depending on board type).
5. Carefully remove the board from the lid.
Source Select Switch Board Remove and Replace
Panel source select boards have overlapping edges that share screws. These
boards can be removed in left to right order with the general procedure
above.
To remove an interior board, loosen the two left-most screws of the left
adjacent board, remove the remaining 4 screws of that left board, then
remove the 6 screws of the right adjacent switch board and carefully tilt the
board out.
Transition Board Remove and Replace
Follow the general procedure above, except carefully unplug the wires con-
necting the Lever Arm to the Transition board before you remove the
screws holding that board to the lid.
Multi-Function Board Remove and Replace
Follow the general procedure above, except after removing the screws you
need tilt the Multi-Function board down and unplug the wires connecting
the Joystick to the Multi-Function board.
Video Processor Frame Maintenance
Video Processor Frame Web Pages
Web browser access is available for the Karrera Video Processor Frame.
Using any web browser able to access the Karrera network, type the Video
Processor Frame IP address in the browser’s Address field to view the fol
-
lowing web pages.
To Next Page
Loading...
