KARRERA — Installation & Service Manual 143
Engineering Setups
Figure 95. TCP/IP—Enter IP Address
9. Enter the desired IP Address (Figure 95), and click OK.
The Subnet mask will be filled in automatically.
10. Click OK.
Enable the FBWF
1. Enable the FBWF (File Based Write Filter), see Setting the IP Address on
page 130, Step 1.
2. Reboot the ClipStore Summit/Solo server.
Camera Control with Ethernet Tally Configuration
The Karrera system uses Ethernet to communicate with the LDK Connect
Gateway (
Figure 96). Some basic configuration is required in the Eng Setup
menu.
To Next Page
Loading...
