66 KARRERA — Installation & Service Manual
Section 4 — System Cabling
Figure 36. Menu Panel Cabling
CAUTION Connect the USB port on the front of the Fanless PC (next to the firewire 1394
port) to the Menu Panel. The default PC settings enable knob control by
mapping Com 3 to that front USB port.
Optional Local Aux Panel Cabling
The Karrera Local Aux Panel is powered from the Karrera Panel, using a
4-pin XLR cable. System control is provided using a RJ-45 connecting cable,
which uses a proprietary communications protocol (not Ethernet).
Redundant AC
Power Sources (2)
AC
Power
Source
8804_28
Touch Screen Menu Panel Bottom View
Fanless PC
Karrera Control Panel (rear)
DVI-D
(straight)
USB
Type B
PCU
Connector
OR
To
Switcher
Network
PC
Power
Input
Gb
Ethernet
USB 2.0 Port
(front side
90 deg.)
12 Volt
DC Out
Power Supply (80 watts)
AC
Power
Source
Power Supply (60 watts)
DVI-D
(rear side
90 deg.)
To Next Page
Loading...
