44
Program description: model memories
The section on pages 18 and 19 explains the basic
method of using the buttons, while the previous double
page explains how to move to the Multi-function list and
reserve a new model memory. At this point we now wish
to start with the “normal” description of the individual
menu points in the sequence in which they occur on the
transmitter itself. For this reason we start with the menu …
Model memory
mod.mem.
servo set.
D/R expo
wing mixer
base sett.
contr set.
phase trim
free mixer
The transmitter can store up to twelve complete sets
of model data, including the digital tr
im values set by
the four trim levers. The trims are automatically stored,
which means that the settings you have carefully estab-
lished through test-fl ying are never lost when you swap
models. If you have entered a model name in the »base
sett.« menu (pages 46 and 50), the name appears in
all three sub-menus of the »mod. mem.« menu follow-
ing the model number and a pictogram of the selected
model type.
Use the rotary cylinder to select the »mod. mem.«
menu, and press ENTER or the rotary cylinder:
Model memories
Calling up a model, erasing a model, copying model ¼ model
Clear model
Hold the rotary cylinder pressed in and select the “clear
model” sub-menu, then press ENTER or the rotary
cylinder
:
select model
clear model
copy mod–>mod
=>
=>
=>
Use the rotary cylinder to select from the list the model
you wish to erase …
03
04
ULTIMATE
02
STARLET
BELL47G
model to be cleared :
01
GRAUBELE
… then press ENTER or the rotary cylinder. The pro-
gram responds with the security query:
model
GRAUBELE
to be erased ?
NO
YES
01
If you answer NO , the process is interrupted, and
you are returned to the previous screen page. If you
answer YES with the rotary cylinder and confi rm your
choice with ENTER or by pressing the rotary cylinder,
then the selected model memory is erased.
Select model
select model
clear model
copy mod–>mod
=>
=>
=>
If you now press the ENTER button or the rotary cylin-
der again, you move to the “select model” sub-menu:
01
03
04
05
¿¿
empty
¿
ULTIMATE
02
GRAUBELE
STARLET
BELL47G
Now use the rotary cylinder to select from the list the
model you wish to use, and confi rm your selection by
pressing the ENTER button or the rotary cylinder. Press-
ing ESC takes you back to the previous menu page
without switching models.
Notes:
If the warning message “Throttle too high” appears •
when you switch models, the throttle stick (Ch 1) is
set towards full throttle and should be moved back
to idle.
If the battery voltage is too low, it may not be possible •
to switch model memories for safety reasons. In this
case the screen displays the following message:
not possible now
voltage too low
To Next Page
Loading...
Need help?
General
