5. Sub-Trim
It is used to set the servo neutral position, and may be used to make ne adjustments to
control surface without hooking linkages and pushrods up. The trim for transmitter stick should
be in center position at the rst and then Sub-Trim should be set. Touch “Sub-Trim” icon in the
base menu to call the “Sub-Trim” setup page. In the setup page, touch “000%” icon to activate
in blue. “Sub-Trim” values can be adjusted with the “INC”, “DEC” icons. When the setting for
“Sub-Trim” is completed, touch “Servo” icon to call “Servo View” page in which you may check
“Sub-Trim” value in a graph. Touch “Back” icon to call “Sub-Trim” setup page and touch “Back”
icon again to call “Base” menu page after setting “Sub-Trim” for every channel.
TouchTouch
Touch
Touch
Touch
Touch
Touch
Touch
Touch Touch
Touch
Touch
16
To Next Page
Loading...
