9. FAILSAFE
When you bind your transmitter, you are programming the receiver with failsafe defaults. If con-
nection is lost between the transmitter and receiver, the receiver immediately operates in those
preprogrammed default positions.
The default value is “Hold” and you may select “Hold” or ”F/S” for up to 12 channels.
CAUTION: Fail safe function should be operated when the transmitter and receiver are switched
on.
• Hold: If you lose connection between the transmitter and the receiver, the preset channels hold
the last given command.
• F/S: If the signal is lost, the preset channels are driven to their failsafe preset position.
In the base page, touch “Fail Safe” icon to call “Fail Safe” setup page. All channels’ default values
are set in “Hold”. Touch “Hold” icon in the channel to set to “F/S” and then touch the “SET” value
to activate in blue. After that, move transmitter stick to the desired position and touch “Set” icon
in the right bottom then the position of transmitter stick is displayed in percentage. Every channel
can be set in the same and when touching NEXT icon in the right, you may call the next setup
page.
You may set “Delay” function after all channels setup, 0.25s is set by default, and may select
any of 3 types ( 0.5s, 0.75s, 1.0s ) by touching the delay mode icon. After “Delay” setup, be sure
to touch “STO1” and “STO2” icons in the right to transmit Failsafe setup data to a receiver. Now
failsafe setup is completed.
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Touch
24
To Next Page
Loading...
