Telemetry
Touch
Telemetry
11. Airbrake (Airplane)
This mixing is used when the airplane is need to land or descent vertically. Airbrake can be
set by AILE, FLAP and ELEV.
Touch “Airbrake” icon in the function setup page to call the airbrake setup page. The rst
page is AILE setup and you may access to FLAP, ELEV and AIRBRAKE DELAY setup page
by touching “NEXT” icon in the top right. Touch “INH” icon in ACT line to switch to “ON”
and touch “ON” in CTL line to call the “Select” message popup. Move the switch or stick or
volume with your choice then that switch or stick or volume is designated as on/ off key and
then the key direction setup page appears. You may select ON or OFF by touching icons.
When the key is moved to the direction of ON, the function is operated. Touch “BACK” icon
to the previous page. Now, you may set the operation value. Touch and activate the values
in blue and adjust them with “INC” and “DEC” buttons. FLAP, ELEV and AIRBRAKE DELAY
can be programmed in the same way after accessing the next page. If you touch SERVO
icon on the top right to call SERVO page, you may check the setup value for Airbrake.
Touch
Touch
Touch
Touch
Touch
Touch
Touch
95
To Next Page
Loading...
Need help?
General
