Touch
Telemetry
Telemetry
5. Idle LOW
It is used to lower the idle speed of the engine temporarily when airplane lands
In FUNCTION page, touch “Idle LOW” icon to call “Idle LOW” setup page and touch and switch
“INH” in ACT line to “ON” then Idle LOW function is activated. Touch “ON” in CTL line to call
“Select” message popup then move the switch with your choice then that switch is designated
as on/ off switch and then the switch direction setup page appears. You may select ON or OFF
by touching icons. When the switch is moved to the direction of ON, the function is operated.
Touch “BACK” icon to return to Idle LOW setup page. Now, you need to set the operation value
of Idle LOW. Touch and activate the value in SET line and set the desired value with INC and
DEC buttons. Touch “BACK” icon to return to FUNCTION page
NOTICE: After setup Idle LOW, make sure to check the arrow direction of throttle channel
6. Prog.MIX
Prog.MIX function is used to mix the different channels for diverse purpose. We recommend
you to use the same “On” switch with the one of Q.LINK. You may set the different program mix
function for each Q.LINK condition.
8 MIXs are available. The mixing method introduced here is divided into 2 type, liner mixing type
and curve mixing type. 1~5 MIXs are liner mixing type and 6~8 MIXs are curve mixing type.
Touch
Touch
Touch
Touch
Touch
Touch
Touch
81
To Next Page
Loading...
Need help?
General
