Telemetry
1. Q.LINK
This function is used to set Q.LINK and assign all switches including sticks, switches, trim levers
and trim switches as Q.LINK selection switches to cope with various ight conditions such as 3D
ight. Since the adjusted value is activated by moving the switch and you can cope with special
tasks with switch, it makes you operating the ight much easier. Q.LINK for helicopter type consists
of 8 types. (NORMAL, IDEL UP1, IDLE UP2, IDEL UP3, HOLD, Q.LINK6, Q.LINK7, Q.LINK8)
Normal type is set as a default value.
In the transmitter main page, touch “Function” icon to call the Function page and touch “Q.LINK”
icon to call Q.LINK setup page. Q.LINK list is displayed. “1.NORMAL” is the default value and it
cannot be changed.
FUNCTION MENU (Helicopter)
Touch
Touch
Touch
Touch
RES
Touch
Touch
Touch
Touch
Touch
RES
Touch
RES
RES
RES
RES
RES
Touch
Touch
RESRES
29
To Next Page
Loading...
Need help?
General
