GReddy Profec - Control Unit Installation

Installation
ControlUnitInstallation
Oncetheelectricalwiringiscomplete,findasuitablemountinglocationforthe
Controlunit.YoumayusetheprovidedAdjustablebracketorflushmounttheunit
withtheprovideddoublesidedtape.
Warning
Forsafety,avoidmountingtheunitnearair-bags.
Caution
Whenusingthedouble-sidedtape,cleanmountingsurfacesfromoiland
debriswithamilddetergentforbestresults.
Important
Besuretomounttheunitinasafelocationthatwillnoteffectsafedriving.
Avoiddirectsunlightandhumidity.
Routetheharnessbetween
thebracketuprights
asshown.
■Howtoinstall■
(1)Adjusttheangleofmounting
brackettofindthebestposition
ofcontroller.Tightenleft&right
bracketboltswithhexwrench.

(2)Placecontrollerinthe
adjustablebracket.Attachthe
backofthecontrollerintothe
reliefinthebracketuntilitlocks
intoplace.Thecontrollercanbe
inverted,sothatthedialonright
sideorleftside.