Gree DC Inverter Multi VRF

DC INVERTER MULTI VRF INSTALLATION
135
2. Install the panel
① Screw the 4 hexagon head screws under the latches in about 15mm. (The panel would rise)
② Adjust the panel by turning it toward the direction pointed by the arrow as shown in fig.4, so that
the adjust board connect the ceiling well.
③ Tighten the screws until the thickness of the sealing material between panel and indoor unit
reduced to 5-8mm.
Air outlet vent
③
Ceiling
Decoration panel
5mm to 8mm
.
Indoor unit
②
Swing flap motor
①
Sealing material
Piping position
Bolt （attachment）
Bolt （attachment）
Fig 4
Note
1. Improper screwing of the screws may cause the troubles shown in fig.5.