Gree FLEXX Series Service Manual

GREE DC INVERTER HEAT PUMP CONDENSING UNIT
84
Removal of electronic expansion valve
NOTE:Before removing the electronic expansion valve, make sure there is no refrigerant in the pipeline and power is cut off.
Step
Picture
Work instruction
6. Secure the
electric box
and arrange
the wires as
required.
 Put the electric box back
in place and tighten up
the screws.
 Arrange the wires as
original.
7. Check and
open the
upper and
front panels.
 Check whether each
component and
connection wire is well
connected.
 If everything is OK,
install the upper, left and
right panels. Tighten up
the screws.
Model: FLEXX60HP230V1AO
Removal of front panel
NOTE: Before removing the front panel, make sure power is cut off.
Step
Picture
Work instruction
1. Remove the upper cover
plate.
 Unscrew the screws of the
upper cover plate with a
screwdriver.

Gree FLEXX Series Specifications

General

Type	Heat Pump
Series	FLEXX
SEER	Up to 20
HSPF	Up to 10
Refrigerant	R410A
Heating Operation Range	-22°F to 75°F
Cooling Operation Range	5°F to 122°F
Operating Temperature Range (Heating)	-22°F to 75°F
Operating Temperature Range (Cooling)	5°F to 122°F
Energy Efficiency Ratio (EER)	Up to 12.5
Dimensions (Outdoor Unit)	Varies by model
Weight (Outdoor Unit)	Varies by model
Compressor Type	Inverter
Power Supply	208/230V, 1Ph, 60Hz
Noise Level	As low as 55 dB(A)