Percussion drill + φ12 drill
Afterburner lever
13# ratchet wrench
18# ratchet wrenchMCCB
The connecting point of the EV supply equipment shall be protected by an RCD having a
rated residual operating current not exceeding 30 mA,RCD(s) protecting connecting points
shall be at least type A, Rated voltage 400V, rated current at least 140A. You need to add
AC molded case circuit breaker with leakage protection function in the front of single
equipment.
3. Transport and Storage
3.1 Storage
3.2 Transport
WARNING:
Condensation inside the cabinet damages the charger.
•
Only transport and store the charging station in its original packaging. No liability can
be accepted for damage incurred when the product is transported in non-standard
packaging.
•
Store the charging station away from exposure to the sun and in a dry environment in
the temperature range stated in the specifications.
•
Disconnect input power before removing the charging station for storage or relocation.
Failure to follow these instructions will result in waiver of warranty and product
damage.
WARNING:
Damaged product
After any transportation, make a detailed visual inspection of the charger with its packaging
opened. Reject the product if there is any visible damage. Make all damage claims to the
transport operator immediately and also immediately inform the sender regarding transport
insurance.
Failure to follow these instructions can result in death, serious injury or equipment damage.
To Next Page
Loading...