6. Preparation for Installation
The following recommendations are intended as a guide to help you prepare for the
installation of the Gresgying DC60kW charging station.
6.1 Safety precautions
You must read and observe the Safety instructions on page 5 at the beginning of this
manual before you install, service, or use the Gresgying DC60kW charging station. The
installer must ensure that the charging station is installed in accordance with the relevant
country-specific standards and local regulations.
6.2 Plan installation
Calculate the existing electrical load to determine the maximum operating current for
the charging station installation.
Calculate the distance from the local power supply panel to the charging station
installation to find the voltage drop. Local regulations may apply and can vary
depending upon the region or country.
Obtain all necessary permits from the local authority that has jurisdiction.
PE grounding connectors must be not spliced.
Refer to local regulations, maximum current and voltage drop to select the conductor
sizes.
Use the correct tools and ensure sufficient material resources and protection
measures.
Make sure that there is good cellular reception where the charging station will be
installed.
Prepare the installation areas with the correct power wiring and data cabling.
Prepare the upstream electric switchboard according to local regulations and the
Gresgying recommendations in Upstream requirements on page 27.
Ethernet network
To connect several Gresgying DC60kW charging station (for network sharing), it is
necessary to install an Ethernet network.
6.3 Select location
The charger is intended for outdoor or indoor areas.
Position the charging station, where possible, in surroundings where it is not exposed to
extreme sunlight and vulnerable to external damage.
The charger is intended for location in a non-restricted area.
To Next Page
Loading...