4.
Figure 9
Figure 9.
5.
Note: We recommend using a silicone RTV
sealant between the gaskets and the chip
pan to avoid leaking lubricants and coolants
into the cabinets.
6. Figure
10
Only use lifting straps and power lifting
equipment rated for at least 1500 lbs. and in
good working condition. If the lathe falls or
tips over while moving it, serious personal
injury and property damage could result.
7.
Figure 11
Figure 11.
8.
9.
Note: Reach into the cabinets to install the
lock washers, flat washers, and hex nuts.
10.
Figure 12
Figure 12.
Figure 10.
To Next Page
