Grizzly G9249 - DRILLING WITH TAILSTOCK; Setting Tailstock for Drilling


 
   thinner 
away
half       
Figure 39
BdkZiV^ahidX`^c
]Va[i]ZY^hiVcXZ
d[i]ZiVeZg#
Figure 39.

10.   Offsetting Tailstock  Page 28

      

  

Drilling with
Tailstock


       
        

To set up the tailstock for drilling:
1. 

2.        

3. 
 Figure 40    
        

Figure 40.


 Note: Alternately, MT#3 tapered drill bits can
be used with the tailstock for drilling opera-
tions (see Figure 41).
Figure 41.

To remove a tapered drill arbor or drill bit:
1.      

