Compound Slide
Handwheel Dial Increments Resolution
Figure 45
Tools Needed Qty
To set the compound slide angle:
1.
Figure 46
Figure 46.
2.
3.
Tool Posts
Tools Needed Qty
To load and use the 4-way tool post:
1.
Figure 47
Note: To properly secure the tool, make sure
a minimum of two post bolts are holding the
tool.
Figure 47.
2.
3. Steps 1–2
4.
Note: The 4-way tool post is aligned in four
positions by an indexing pin in the compound
slide that engages slots in the tool post
base.
To Next Page
