Using the 3-Jaw Chuck
Figure 25
8aVbe^c\^cVc>ch^YZ9^VbZiZg
8aVbe^c\dcVcDjih^YZ9^VbZiZg
Figure 25.
Tools Needed Qty
To mount a workpiece in the 3-jaw chuck:
1.
2.
3.
4.
Figure 26
Figure 26.
Tools Needed Qty
To remove and install the jaws:
1.
2.
3.
Note: If this is the first time you are removing
the jaws, mark each jaw and its jaw guide
with a numbers 1–3. Returning the jaws to
the same jaw guide on the chuck will make
installation easier.
4.
Note: Store jaws in a place free from mois-
ture and abrasives.
To Next Page
