Grizzly G9249 - Page 41

 

7. 
Figure
56
Side
View
Front
View
(%(%
('
&'%
&',
&',
&'%
('
Figure 56.
;aVc\Z
@ZnlVn
Figure 57.
8.        
Figure 57

       


9.        





      




NOTICE
For smooth operation and to reduce wear
of the change gears, always make sure to
clean away debris and built-up grime, then
apply a light film of multi-purpose gear
grease to the gear teeth.
10.        


 Note: It may be necessary to re-position the
middle change gears on the pivot bracket
to properly mesh with the top and bottom
gears.
11. 
      
       

 Note: Setting the gears too tight will cause
excessive wear and noise. Setting the gears
too loose may cause slippage and gear tooth
breakage.
12.       
