Grizzly G9249 - Page 7

 

The information contained herein is deemed accurate as of 5/29/2008 and represents our most recent product specifications.
Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased.
PAGE 2 OF 3Model G9249
Main Specifications:
Operation Info
Swing Over Bed......................................................................................................................................... 12 in.
Dist Between Centers.................................................................................................................................37 in.
Swing Over Cross Slide......................................................................................................................... 6-3/4 in.
Swing Over Saddle................................................................................................................................ 6-1/2 in.
Swing Over Gap...................................................................................................................................18-7/8 in.
Max Tool Bit Size...................................................................................................................................... 5/8 in.
Compound Travel...................................................................................................................................3-1/2 in.
Carriage Travel.................................................................................................................................... 31-1/2 in.
Cross Slide Travel........................................................................................................................................ 6 in.
Headstock Info
Spindle Bore.........................................................................................................................................1-7/16 in.
Spindle Size........................................................................................................................................... 2-1/4 in.
Spindle Taper.............................................................................................................................................MT#5
Spindle Threads................................................................................................................................................ 8
No Of Spindle Speeds.....................................................................................................................................12
Range Of Spindle Speeds.......................................................................................................... 50 - 1200 RPM
Spindle Type........................................................................................................................................Threaded
Spindle Bearings......................................................................................................................... Tapered Roller
Tailstock Info
Tailstock Travel............................................................................................................................................ 3 in.
Tailstock Taper.......................................................................................................................................... MT#3
Tailstock Barrel Diameter.......................................................................................................................1-1/4 in.
Threading Info
No Of Inch Threads.........................................................................................................................................50
Range Of Inch Threads..................................................................................................................... 4 - 112 TPI
Range Of Longitudinal Feeds............................................................................................... 0.0047 - 0.0165 in.
No Of Longitudinal Feeds............................................................................................................................... 16
No Of Cross Feeds......................................................................................................................................... 16
Range Of Cross Feeds.................................................................................................. 0.0023 - 0.0082 in./rev.
No Of Metric Threads......................................................................................................................................24
Range Of Metric Threads..............................................................................................................0.25 - 7.5 mm
Dimensions
Bed Width...............................................................................................................................................7-1/8 in.
Leadscrew TPI.................................................................................................................................................. 8
Leadscrew Length...................................................................................................................................... 45 in.
Faceplate Size............................................................................................................................................10 in.
Leadscrew Diameter................................................................................................................................. 7/8 in.
Feed Rod Diameter................................................................................................................................... 3/4 in.
Floor To Center Height.........................................................................................................................44-1/2 in.
Construction
Base Construction................................................................................................................................ Cast Iron
Headstock Construction....................................................................................................................... Cast Iron
Headstock Gears Construction.............................................................................................................Cast Iron
Bed Construction..................................................................................................Induction Hardened Cast Iron
Body Construction................................................................................................................................ Cast Iron
Stand Construction........................................................................................................................ Formed Steel
Paint.......................................................................................................................................................... Epoxy
Other
Kilowatt Output...........................................................................................................................................1.119