Grizzly T31739 - Default Chapter; Table of Contents

Table of Contents
INTRODUCTION ............................................... 2
Contact Info.................................................... 2
Manual Accuracy
........................................... 2
Identification
................................................... 3
Controls & Components
................................. 4
Machine Data Sheet
...................................... 5
SECTION 1: SAFETY
....................................... 7
Safety Instructions for Machinery
.................. 7
Additional Safety for Drill Presses
................. 9
SECTION 2: POWER SUPPLY
...................... 10
SECTION 3: SETUP
....................................... 12
Needed for Setup
......................................... 12
Unpacking
.................................................... 12
Inventory
...................................................... 13
Hardware Recognition Chart
....................... 14
Cleanup
........................................................ 15
Site Considerations
...................................... 15
Bench Mounting
........................................... 16
Assembly
..................................................... 16
Joining Drill Chuck & Arbor
.......................... 18
Test Run
...................................................... 19
SECTION 4: OPERATIONS
........................... 20
Operation Overview
..................................... 20
Choosing Spindle Speeds
........................... 21
Changing Spindle Speed
............................. 22
Installing/Removing Chuck Arbor
................ 22
Installing/Removing Drill Bits
....................... 24
Using LED Worklight
.................................... 24
Adjusting Depth Stop
................................... 24
Positioning Table
......................................... 25
Adjusting Laser Sight
................................... 26
SECTION 5: ACCESSORIES
......................... 27
SECTION 6: MAINTENANCE
......................... 28
Schedule
...................................................... 28
Cleaning & Protecting
.................................. 28
Lubrication
................................................... 28
SECTION 7: SERVICE
................................... 30
Troubleshooting
........................................... 30
V-Belt Tension & Replacement.................... 32
Calibrating Depth Stop
................................. 32
Replacing Lasers & LED Worklight
............. 33
Adjusting Spring Tension
............................. 35
SECTION 8: WIRING
...................................... 36
Wiring Safety Instructions
............................ 36
Wiring Diagram
............................................ 37
SECTION 9: PARTS
....................................... 38
Main
............................................................. 38
Labels & Cosmetics
..................................... 40
WARRANTY & RETURNS
............................. 41