Growatt MOD 11KTL3-X Manual

Error code
Description
Suggest
Error 400
DCI bias abnormal
1 .Restart inverter
2.If error message still exists, contact manufacturer.
Error 401
DC Voltage High
Fault
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 402
Output DC current
too high.
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 403
Ou t pu t cu r r e n t
unbalance
1 .After shutdown,Check the output current is not balanced.
2. If the error message still exists, contact manufacturer
Error 404
bus sample fault
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 405
Relay fault
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 406
Init model fault
1 .Reset mode
2.If error message still exists,contact manufacturer.
Error 407
AutoTest failure
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 408
NTC Temperature
too high
1 .After shutdown,Check the temperature, normal restart the
inverter
2. If the error message still exists, contact manufacturer
Error 409
Bus v o l tage ab-
normal
1 .Restart inverter.
2.If error message still exists,contact manufacturer.
Error 41 0
Co mm un i c at i o n
board and control
p a ne l s a m p l ing
battery voltage is in-
consistent
1 .Restart inverter
2.If error message still exists, contact manufacturer.
Error 411
Co mm un i c at i o n
fault
1 .After shutdown,Check communication board wiring 2. If
the error message still exists, contact manufacturer
Error 412
T e m p e r a -
t u r e sensor con-
nection is abnormal
1.After shutdown,Check the temperature sampling module is
connected properly
2.If the error message still exists, contact manufacturer
42

Growatt MOD 11KTL3-X Specifications

General

Product type	-
Maximum power	11000 W
Output current	18.3 A
Output frequency	50/60 Hz
MPP voltage range	140 - 1000 V
Number of strings per MPPT	1
Output power capacity (max)	11 kVA
Input operation voltage (max)	1100 V
Input operation voltage (min)	160 V
Maximum input current per MPPT	13 A
Output operation voltage (max)	440 V
Output operation voltage (min)	340 V
Total Harmonic Distortion (THD)	3 %
Number of maximum power point tracking (MPPT)	2
Operating temperature (T-T)	-25 - 60 °C
Built-in display	Yes
Display technology	OLED
Product color	White
Overvoltage category	CAT II
Power protection features	Over voltage, Short circuit
International Protection (IP) code	IP66

Weight and Dimensions

Depth	178 mm
Width	425 mm
Height	387 mm