Grundfos ALPHA1 L - Insulating the Pump Housing

Step Action Illustration
6
Tighten the screws
on the power supply
plug.
x 3
TM068548
7
Refit the terminal
cover. See A.
Note: It is possible
to turn the power
supply plug on the
side for a 90 ° cable
entry.
See B.
TM068550TM068549
8
Tighten the union
nut.
TM068551
9
Tighten the cable
gland onto the pow-
er supply plug.
TM068552
10
Insert the power
supply plug into the
male plug on the
pump.
TM068553
3.5 Insulating the pump housing
TM068564
Insulating the pump housing
You can reduce the heat loss from the pump and pipe by insulating
the pump housing and the pipe with insulating shells, which can be
ordered as an accessory. See section Insulating shells.
Do not insulate the control box or cover the operating pan-
el.
Related information
5.5.2 Insulating shells
9
English (GB)