Grundfos CRE - Page 33

"Installation"
CRE, CRIE, CRNE, CRKE, SPKE,
MTRE
CME Multipump system
"Control mode" ● ●
"Controller" ("Controller settings") ● ●
"Signal relays" 1 and 2 ("Relay outputs") ● ●
"Buttons on product" ("Enable/disable settings") ● ●
"Number" ("Pump number") ● ●
"Digital inputs" ● ●
"Digital inputs/outputs"
"Digital input/output 3 and 4, State" ● ●
"Digital input/output 3 and 4, Function" ● ●
"Analog inputs"
"Analog input 1, 2 and 3, Function" ● ●
"Analog input 1, 2 and 3, Measured parameter" ● ●
"Analog input 1, 2 and 3" ● ●
"Pt100/1000 inputs"
"Pt100/1000 input 1 and 2, Function" ● ●
"Pt100/1000 input 1 and 2, Measured parameter" ● ●
"LiqTec" ("LiqTec function") ● ●
"Operating range" ● ●
"Ramps" ● ●
"Motor bearing monitoring" ● ●
"Service" ● ●
"Standstill heating" ● ●
33
English (US)