ENGLISH
14
CONNECTION AND PREPARATION
---------------------------------------
Connecting to the mains supply
Notes:
7
Check that the mains voltage on the type
plate (on the back of the power adapter)
corresponds to your local mains supply. If
this is not the case, contact your specialist
dealer.
7
Before connecting the power adapter plug
to the wall socket, ensure that all other con-
nections have been made.
1 Insert the plug of the supplied power adapter
cable into the »DC IN« socket on the back of
the device.
2 Plug the power adapter into the wall socket.
Caution:
7
The device is connected to the mains with the
power adapter. Pull out the power adapter
plug if you want to completely disconnect
the device from the mains.
7
Make sure that the power adapter plug is
easily accessible during operation and not
hindered by other objects.
Putting battery in the remote
control
1 Open the battery lid by pressing on the arrow
and sliding the lid out.
2 Insert two batteries (2 x 1.5 V, R 03 /UM 4/
AAA) into the battery compartment with the
correct polarity.
3 Close the lid of the battery compartment.
Notes:
7
Do not expose the batteries to extreme heat,
caused for example by direct sunlight, heat-
ers or fire.
7
Remove the batteries when they are flat or
when you know that the device will not be
used for a long period of time.
Environmental note:
7
Batteries, including those which do not con-
tain heavy metal, should not be disposed
of with household waste. Always dispose
of used batteries in accordance with local
environmental regulations.
To Next Page
Loading...
Need help?
General