ENGLISH
40
5 Select the network by pressing » « or » «
or by turning the Jog-Shuttle, and confirm by
pressing »OK«.
– The »Key« menu appears (if the network is
encrypted), and the cursor is positioned at
the first input field.
Note:
7
If the network is encrypted, the network
key (security code WEP or WPA) must be
entered.
6 Enter network key:
Enter the first character by pressing » «, » «,
» « or » « or by turning the Jog-Shuttle and
confirm by pressing »OK«.
Repeat entry for the remaining characters.
When the network key has been entered
completely, select the push button »OK« by
pressing » «, » «, » « or » « and confirm
by pressing »OK«.
– The »Internet Setup« menu appears, the reg-
istration on the network is processed.
Notes:
7
Numbers, capital and lower case letters as
well as special characters are available for
input.
7
Scroll through the menu pages by pressing
» « or » « in order to select other char-
acters.
7
If you make a mistake during entry, press
» «, » «, » « or » « to select the push but-
ton »BKSP« and confirm by pressing »OK«.
The last character is deleted.
7
If you wish to exit the menu prematurely,
press » «, » «, » « or » « to select the
push button »CANCEL« and confirm by
pressing »OK«. The device switches back
one menu level.
– After successful registration, the message
»Setup wizard completed« appears.
7 End the setting by pressing »OK«.
Setting the WLAN region
You must set the WLAN region in accordance
with the location of the device.
1 Press »MENU« to open the menu.
2 Select the option »System settings« by pressing
» « or » « or by turning the Jog-Shuttle and
open using »OK«.
3 Select the option »Network« by pressing » «
or » « or by turning the Jog-Shuttle and open
using »OK«.
4 Select the option »Wlan region« by pressing
» « or » « or by turning the Jog-Shuttle and
open using »OK«.
Time/Date
Internet Setup
Internet Wizard
PBC Wlan setup
View settings
Wlan region >
Manual settings
5 Select the appropriate WLAN region using
» « or » « or by turning the Jog-Shuttle and
confirm by pressing »OK«.
Deleting servers which cannot
be accessed
This function allows you to delete servers for
which access data is still stored in the device, al-
though they are no longer available.
1 Select the input source »Music player« by
pressing »M« on the remote control or by
pressing »MODE« on the device.
2 Select the option »Prune servers« by pressing
» « or » « or by turning the Jog-Shuttle on
the device, and confirm by pressing »OK«.
3 Select the push button »YES« by pressing
» « or » « or by turning the Jog-Shuttle and
confirm by pressing »OK«.
Note:
7
If the push button »NO« is selected and
confirmed, then the deletion process will be
cancelled.
SPECIAL SETTINGS
To Next Page
Loading...
Need help?
General