Safety Warning
VI
Safety Warning
● The product is not designed and manufactured to be used in machines or systems
threatening personal safety.
● When selecting the product, the customers shall consider safety protection measures when
designing and manufacturing their machines and systems, so as to avoid improper
operation or irregular accidents of the product.
Acceptance
● Damaged or broken-down products shall not be put into use.
Transportation
● Products must be stored and transported under conditions for storage and transportation.
● Over-height piling shall not be allowed to prevent products from falling.
● When being transferred, the products concerned shall be properly packed.
● The servo motor shall not be moved by drawing its wire, motor shaft or encoder.
● Outside force and impact shall not be imposed on servo drive units and servo motors.
Installment
Servo drive units and servo motors:
● Shall not be installed above or around combustible articles to prevent fire disaster.
● Shall avoid vibration. Impact shall be strictly forbidden.
● Shall not be installed when they are damaged or the parts are incomplete
Servo Drive unit:
● Must be installed in the control panel with sufficient degree of protection.
● Must keep sufficient intervals away from other equipment.
● Must have good conditions for heat emitting.
● Must prevent invasion of dust, corrosive air, conductive matters, liquid, combustible and
explosive substances.
Servo motors:
● Must be firmly installed to prevent loosening under vibration
● Must prevent motor and encoder from being damaged by the invaded liquids
● Shock on motor and motor shaft shall be strictly forbidden to prevent the encoder from
being damaged.
● Load surpassing its limit shall not be imposed on the motor shaft.
Warning
Attention
Attention
Attention
To Next Page
Loading...