Safety Warning
Ⅷ
not touch the servo drive unit’s radiator or the servo motor with your hand within a short
time after the power is off.
● Do not refit the servo drive unit.
Failure Handling
● Even after the power of servo drive unit has been cut off, the voltage will remain for some
time. So do not dismantle the wire or touch the plate of terminals.
● Personnel involved in dismantlement and repair must possess corresponding professional
knowledge and working capacity.
● In case of alarming, the trouble must be shot. Before restarting the machine, the alarming
signal shall be reset.
● Keep away from the machine when re-switching on the power after instantaneous power
failure, for the machine may be restarted suddenly (when designing the machine, make
sure that there will be no danger when restarting the machine).
System Selecting and Matching
● Rated torque of the servo motor shall be greater than the valid continuous load torque.
● The ratio of load inertia to servo motor inertia shall be less than the recommended value.
● When selecting servo drive unit and servo motor, they shall be matched with each other.
Attention
Attention
Attention
To Next Page
Loading...