GSM Power Socket - Password Management

GSM POWER SOCKET USER MANUAL
17
 GSM Power Socket will reply to the user after it receives the SMS
command.
 Note
 The “#” symbol must not be ignored when typing an SMS
command.
 No allow any space within the commands.
3.1.3 Add a master number to the socket
 Description
If GSM Power Socket is being used for the first time, or GSM Power
Socket has been reset to factory settings, the Master user’s
number must be programmed into the socket.
 Method
The user must edit and send the following SMS to socket via
his/her mobile phone (the phone number will be the Master
number) in order to:
Add a master number to the socket: #00# (2)
 Successful SMS reply
Welcome to use GSM Power Socket.
Your Password is:1234..
 Failed SMS reply
If a user tries to add another Master user again, GSM Power
Socket will send a notification via SMS stating “The master user
already exists.”. The Master number should be changed. (Refer
to Chapter 3.1.4)
3.1.4 Change the master number
 Method
Method 1:
The Master user sends following SMS message in order to:
Change the master user’s number: #14#NewMasterNumber (3)