Note: When tted, the handlebar plate will not t
ush against the handlebar stem. There will be
a small gap. Ensure that the gap is even on the
top and the bottom of the handlebar.
Using the Gtech tool, tighten all of the screws
evenly by turning them clockwise. Tighten
in small increments in a criss-cross pattern.
The handlebars should be secure but do not
overtighten the screws.
Carefully insert the four screws (with washers)
making sure the threads are engaged well.
Screw in by hand, starting with two that are
diagonally opposite.
Place the handlebar plate so that it’s in front of
the handlebars and aligned with the holes on the
handlebar stem.
Note: The handlebar plate can go either way up.
1
2
3
4
To Next Page
Loading...