Removing the rear wheel
Detach your brakes, which are located at the top
of the rear forks, from the wheel rim by closing
the brake arms using your thumb and index
nger and lifting out the brake cable. If there
is not enough play, loosen the adjusters at the
handlebars.
Adjust the saddle so that it is at its lowest
position. Turn the bike upside down and place
on a soft surface.
Disconnect the hub connector cable.
Locate the hub connector cable on the left hand
side of the frame (the same side as the drive
belt). Using the tool undo the cable guide holding
the hub connector cable in place.
To Next Page
Loading...