Gtech EB01 - Inflating the Tyres

49
Maintenance
Inating the tyres
Remove the valve cap. Briey press down on the valve to make sure the
valve doesn’t stick and to remove any loose dirt.
Press the pump nozzle onto the tyre valve stem
as far as it will go.
Lift the thumb lock lever into the locked position.
The wear indicator is the black line that runs around your wheel rim. If the wear
indicator becomes invisible the rim should be replaced.
Before starting to inate your tyres, check that the pump is in the correct mode for your tyre valve.
For the Gtech eBike, it will need to be in Schrader mode.