Tuck the rubber mudguard ap under the crown
of the fork and fasten the press stud to secure.
Locate the front mudguard and place the end
into the steerer tube.
Insert the bolt through the steerer tube and
mudguard.
Place the gtech tool into the bolt, and turn it
clockwise to tighten the mudguard until it can no
longer rotate.
Attaching the front mudguard
The front and rear mudguards are an optional accessory, available from www.gtech.co.uk.
Once attached, these steps can be reversed to remove the mudguards from the bike.
To Next Page
Loading...
