Gtech eSCENT - Inflating Tyres and Pressure Guidelines

26
Maintenance
Inating the tyres
Remove the valve cap. Briey press down on the valve to make sure the
valve doesn’t stick and to remove any loose dirt.
Press the pump nozzle onto the tyre valve stem
as far as it will go and lift the thumb lock lever into
the locked position.
Before starting to inate your tyres, check that the pump is in the correct mode for your tyre valve.
For the Gtech eBike, it will need to be in Schrader mode.
Pull out the end of the bicycle pump and push
down to start inating the tyre, continue to do this
until you have reached the desired tyre pressure.
Do not inate beyond the maximum tyre pressure
printed on the sidewall of the tyre.