Place the bike upside down on a at surface,
resting on the saddle and the handlebars.
You may need to put something down on the
surface to stop your handle bars from getting
scratched. Pull the quick-release lever on the
front wheel, so that it is fully open.
Remove the wheel.
Loosen the adjustment nut by turning
it anti-clockwise approximately 5 full rotations.
Removing the front wheel
Make sure that the front brake is not pressed whilst removing the front wheel.
This will cause the brakes to seize and will need to be repaired. Please insert the
provided pad spacers when travelling or leaving the bike without a wheel attached
for a long time.
To Next Page
Loading...
