1. Insert inner tube into the tyre at the valve
location.
2. Pull the valve through the hole in the rim.
Pinch the tyre back onto the rim then use the tyre
lever to push the edge of the outer tyre under the
wheel rim, all the way around the tyre.
Squeeze the tyre into the rim on both sides to
prevent pinching.
Feed the rest of the inner tube evenly around the
inside of the tyre.
Inate the inner tube to the correct pressure.
Ret the wheel onto the bike (see page 36).
The correct pressure for the tyres on the Gtech eBike is: min 30psi, max 50psi.
Do not over or under inate the tyres.
1
2
To Next Page
Loading...
