EMP
to
access the main function mode.
Press the Up and Down arrow keys
to select the resistance measurement
mode (shown above).
There are three different modes:
(resistance), (temperature)
and
(temperature compensation)
mode.
Press ENTER to confirm.
3. Resistance
mode and
Compare display
appears.
4. Resistance
Range
Press the Up and Down arrow keys
to manually select the resistance
range.
5. Select the
Scan mode.
Press SHIFT + NORMAL
SCAN
to
access the scan mode.
Press the Up and Down or Left and
right arrow keys to select the
number of counts.
Count range 0~100
Press ENTER to confirm.
6. Select the
Delay time.
Press the Up and Down or Left and
Right arrow keys to set the sweep
delay time. Each count unit has a
delay time of 16.2 ms.
To Next Page
Loading...
