GW Instek GPP-3323 - Page 136

GPP Series User Manual
136
Description
[FAST]: In order to protect the function switching
device” relay”, it is necessary to wait until the voltage
and current drop to zero under normal conditions.
When FAST is enabled, this factor will not be
considered, but it is easy to damage the “relay”, so it is
recommended to use it with caution.
Example
:LOAD2:CC ON
Sets CH2 as Load CC mode.
Command
:LOAD[1|2]:CR {ON|OFF}
Function
Sets CH1/CH2 as Load CR mode.
Example
:LOAD2:CR ON
Sets CH2 as Load CR mode.
Command
:MODE[1|2]?
Function
Queries CH1 or CH2 work mode.
6 modes below:
SERies，PARallel，INDE pendent
CV Load，CC Load，CR Load
Example
:MODE1?
Queries CH1 work mode.:
Command
:LOAD[1|2]: RESistor <NRf>
Function
Sets the Load CR level.
Description
<NRf>
1-1000
Example
:LOAD2: RESistor 100
Sets the Load CR level to 100Ωfor CH2.
Command
:LOAD[1|2]: RESistor?