To Next Page

To Previous Page

GPP Series User Manual

158

Function

Enable or disable sequence function.

To enable sequence will change state of channel

output, make sure the changed output state will

Not impact the device connected with power before

enabling. Sequence output is activated only when

both sequence and channel output are enabled. To

modify parameter is Not available when sequence

is being enabled. For multi-channel model, change

the active channel and set parameter of selected

channel. It is Not allowed to enable sequence and

delay simultaneously.

Example

:SEQUence2:STATe ON

Enable sequence output for CH2

Command

:SEQUence[1|2] [:STATe]?

Function

Queries the state of sequence output .

Example

:SEQUence2:STATe?

Queries the CH2 state of sequence output. Returns

to ON or OFF.

Command

:SEQUence : SYNChronize {ON|OFF}

Function

When both CH1 and CH2 are sequence on, turn on

or off the sequence synchronization between them.

Example

: SEQUence : SYNChronize ON

turn on the sequence synchronization of CH1 and

CH2.

Command

:SEQUence[1|2]:TEMPlet:CONSTruct

Function

Sends the command. Instrument builds, based on

the actively selected templet and set the sequence

parameter.

GW Instek GPP-3323 User Manual

Questions and Answers: