optional settings: administrator options
file: n:\article\cos14310m5-v1_08hpc-en\20150130_cos14310m5-v1.08hpc-en_instructions_for_use_h-p-cosmos_treadmill.doc
© 2015 h/p/cosmos sports & medical gmbh author: fh email@h-p-cosmos.com created 30.01.2015 printed 30.01.2015 page: 149 of 216
The standard maximum speed of the selected device type (in
OPTION 03) will be indicated in the SPEED display.
Example: h/p/cosmos mercury 4.0 = 22.0 km/h; h-p-cosmos discovery
4.0 = 40 m/min
For safety purposes (e.g. for beginners), the max. speed of every
treadmill model can be limited.
= indicates: maximums speed,
adjustable range from 1 km/h to maximum treadmill speed
selected unit is blinking, max. is blinking
Maximum acceleration time in
seconds
(This option is only available for
treadmills, not for ladder
ergometers).
§ reports e.g. 131 (max. acceleration increment)
$ reports e.g. 5.0 (max. acceleration time in seconds.)
% indicates: SEC.
Maximum elevation
(This option is only available for
treadmills, not for a ladder-
ergometer).
The standard maximum elevation of the selected device type (in
OPTION 03) will be indicated.
Example: h/p/cosmos mercury = 25 %
For safety purposes (e.g. for beginners, or in case the ceiling height
of the room's ceiling is insufficient) the max. elevation of every
treadmill model can be limited.
$ indicates: maximum elevation, adjustable range from 0 to
maximum treadmill elevation
Heart rate display interval
§ indicates heart rate display interval in seconds,
adjustable range from 0 (beat to beat) .... 1 to 9 seconds
Compare: An original POLAR heart rate monitor has a display interval
of 5 seconds
$ indicates: SEC
Test of all displays and LEDs
Enter the serial number of the
device provided on the nameplate
Change the values with a or d, confirm the values with c
Example: Treadmill with serial number cos30000va05-0128 on the
nameplate
§ indicates 300 (item number of device)
$ indicates: 0005 (item number of device)
% indicates: 0128 (serial numbers of this device family)
Activating and de-activating speed
measurement
Speed measurement is normally activated / de-activated by selecting
the correct device type (administrator option number 3). Only in very
special cases a special adjustment in option number 11 is necessary.
Speed measurement can only be activated if the device has a speed
sensor.
§ indicates
0 = without speed measurement / -sensor
1 = with speed measurement / -sensor
(permanent control)
2 = with speed measurement / -sensor
(control as of speed > 2 km/h, no control < 2 km/h)
To Next Page
Loading...
