h/p/cosmos pluto - Optional Settings: User Options

operation
file: n:\article\cos14310m5-v1_08hpc-en\20150130_cos14310m5-v1.08hpc-en_instructions_for_use_h-p-cosmos_treadmill.doc
© 2015 h/p/cosmos sports & medical gmbh author: fh email@h-p-cosmos.com created 30.01.2015 printed 30.01.2015 page: 76 of 216
5.11 Optional settings: User Options
Optional settings serve for example as confirmation of error notes on the display, or for the standard setting of the
device: selection of RS232 interface protocol, etc. For optional settings on devices without UserTerminal, an external
UserTerminal or a connected PC with the software h/p/cosmos para control
®
is required.
Select user options
Initiation: Running belt is not moving. One of the modes LED  is flashing: (manual, profile, cardio, test)
Step no.
Activity
Keys
Response / Display
[01]
Select option mode (OPxx)
for users
Note: The option mode for
administrators is only
accessible for authorised
service technicians, not for
users
a
and simultaneously
d
and simultaneously
b
for at least 3
seconds.
= indicates: OP 01 flashing (for option no. 01)
! and " indicating: E.rE SEt (for error reset)
[02]
Select option no. 01 ... 53
a or d
= indicates: OP 01 ... OP 53 flashing
! and " indicate: a short explanation of the
option, e.g.: E.rE SEt (for Error reset)
[03]
Confirm option no.
c
Read, confirm and set options according to the following
option list. All adjustable values are going to be shown
flashing. All non-adjustable values are not going to be
shown flashing.
[04]
Example: OP 01 (OIL &
other error codes):
Confirmation & deleting by
pressing:
c
Display indicates: donE (confirmation)
[05]
Example: OP 02 (Distance /
km): Confirmation by
pressing
c
[06]
Example: OP 08
(STOP-time / "slow-down-
time"):
a) change value by pressing
b) confirm value by pressing
a) a or d
b) c