h/p/cosmos pluto - Page 53

operation
file: n:\article\cos14310m5-v1_08hpc-en\20150130_cos14310m5-v1.08hpc-en_instructions_for_use_h-p-cosmos_treadmill.doc
© 2015 h/p/cosmos sports & medical gmbh author: fh email@h-p-cosmos.com created 30.01.2015 printed 30.01.2015 page: 53 of 216
Possibilities of interfering within the profile mode manually
Initiation: Profile mode is selected, running-belt is moving
Step no.
Activity
Keys
Response / Display
[01]
Alteration of speed
a or d
press and hold
Speed is being increased / reduced (0 - max)
If speed is being reduced to 0, PAUS is displayed =.
Current values will be sustained.
Alteration of the speed is online only for this single step. The
speed cannot be changed in the memory. Next program step
as defined in the profile.
[02]
Alteration of acceleration /
deceleration
c
press several times
and then hold
Example: to select acceleration or deceleration level “3”, press
the corresponding key 3 times and then hold.
(Standard value = 4, maximum 7 levels, may be limited by
optional settings)
[03]
Pause mode =interfere with a
program step
a
= indicates PAUS. Running belt stops. All displays stop.
Current values will be sustained.
After restart with d or c all displayed values will be added.
[04]
Alteration of elevation
f or e
press and hold
Elevation is being increased / reduced (0-max.)
Alteration of the elevation is online only for this single step. The
elevation cannot be changed in the memory. Next program
step as defined in the profile.
[05]
Switch over to the next or
previous program step
c
and simultaneous
e or f
Jump over to the next program step, or jump to the previous
program step.
[06]
Switch to the next or previous
mode
c + d
or
c + a
Switch to the next or previous mode.
This is a perfect way to change the mode without stopping the
belt.